★ How to clean a silicone doll? (With cleaning tools)

The silicone doll package includes an accessory pack containing a vaginal irrigator and a drying stick.

 

After use, please clean all parts of the doll with warm water and mild bath gel or soap as soon as possible.

Soak a sponge or soft cloth in warm water and gently wipe the surface of the doll. Do not scrub vigorously.

 

Steps for Cleaning:

 

1) Place a soft white towel beneath your doll to catch any overflow water from the area being cleaned.

2) Do not allow water to enter the neck bolt hole to prevent water intrusion and rust. (Dolls using ultra-lightweight technology need to have the waterproof plug installed correctly.)

 

1) Fill the container of the vaginal irrigator with water. (Warm water temperature should not exceed 50°C)

2) Add a small amount of mild bath gel or soapy water

3) Secure the nozzle and shake the bottle to mix the solution thoroughly.

 

Notes:

1) Avoid using corrosive cleaning agents, such as strong acids, alkaline solutions, powerful disinfectants, or irritating detergents.

2) Use mild cleaning agents: mild soap, liquid shower gel, or mild cleaning products.

 

1) Insert the nozzle into the entry you wish to clean.

2) Gently squeeze the bottle to irrigate the area.

3) Repeat this process several times.

 

1) Remove the nozzle and empty the soapy water.

2) Refill the bottle with fresh water (no soap).

3) Repeat the irrigation process multiple times to ensure all soap residue is fully rinsed out.

 

Important: Leaving soap in the cavities may cause irritation during use. Rinse thoroughly.

 

1) Allow excess water to naturally drain from the cavity. You may pat dry the outer areas with a soft towel if needed.

2) Gently insert the drying stick into the tunnel and leave it for 15-30 minutes. Then the doll's belly and hips can be squeezed appropriately to facilitate the stick absorbing the water inside. The stick is left in place for about 15-30 minutes, then take out it. Do not leave the drying stick in the channel for a long time, so as not to cause the channel to tear.

 

If you find that there is still moisture in the tunnel after taking out the stick, you can replace another stick and continue to place it for about 15-30 minutes. And then place the doll in a dry and ventilated place and let it dry completely. (It is recommended to dry the absorbent stick under the sun or in a well-ventilated area.)

 

Please remove the drying stick before storing to avoid channel tearing. And ensure that the doll's tunnel is completely dry that no moisture remains to prevent the growth of bacteria and mould.

 

Proper cleaning helps extend the life of your silicone doll and ensures safe, hygienic use.